This is a remix of, "DtM-v3.1 Face Shield PPE, 3D printable headband NO LOGO" (Model ID 3DPX-013359). This model remains largely unaltered from its parent model. Our group #3DPPGH has printed a number of the parent file and noticed that there were very strange retractions and artifacts stemming from the fact that the splatter guard did not have a consistent width. This means that at certain points, slicing software would have to switch between gap fill and perimeters because the thickness was not a consistent 2.4mm. I fixed this problem and left the front face and pegs of this model alone. The model can now print without excess retractions and blobs and therefore is easier to sanitize.