The following refers to: 3DPX-013306

The FDA has authorized production of protective face shields outside of the normal clearance pathway during the COVID-19 pandemic, based on Part 5, section D of the “Enforcement Policy for Face Masks and Respirators During the Coronavirus Disease (COVID-19) Public Health Emergency Guidance for Industry and Food and Drug Administration Staff." This face shield has undergone review in a clinical setting and is recommended when fabricated as instructed.

There is a shortage of protective gear for doctors and nurses, so 3DVerkstan designed a frame for holding standard sized plastic sheets. Quick to print, easy to assemble.

• Using readily available plastic sheets with as little modification as possible, and only common tools used.
• All features printable with nozzle sizes up to 1mm and layer heights up to 0.5mm 
• Drip protection above the eyes
• Printable in less than 20 minutes
• No tight tolerances requiring well-tuned printers.
• Design that works equally well with most common materials (PLA, CPE, PETG, ABS etc.)

The visor is tested and approved by staff all over the world but there are a lot of different regulations regarding medical supplies, please make sure to follow authority guidelines that applies within your region.

This model has been approved by Columbia University Medical Center/New York-Presbyterian Hospital staff, who are currently using hundreds of them. 

More information can be fonud at the designers web site:

https://3dverkstan.se/protective-visor/

You can also find the files and lisence here:

https://github.com/Cederb/Faceshield.nu/