Printed with supports using PETG filament (Taulman Guidel!ne). Autodesk 123D Design was used to solidify the humerus with a sphere and cylinder because the stl had unnecessary holes and interior bone structure. Several spheres were also added to connect the humerus and clavicle to the scapula. The model was then combined and exported to Autodesk Meshmixer where it was made solid in the editor. It was then exported as an stl and gcode compiled using Slic3r. Slic3r was used to trim the end of the clavicle so it would fit the build volume of the printer.