Overall Evaluation:\tTakes about 4 hours to print.\t\tHigh quality print with some stringing. (Possibly do to the age of the filament used)\t\tThere are some ringing artifacts found on the right side of the visors. The artifact does not affect the functionality of the visor. \t\tThe transparency snaps perfectly to the locations. \t\tCurrently have printed 15.  \tSettings Used:\tI used recommended settings for .2mm (Speed). The only thing that I changed later on was the speed. I increased it to 120% in order to reduce the amount of vibration and sound that was created. Increasing the speed to 120% did not show any negative effects on the print. Ringing was still present.  \tNext Steps: \tThe quality of this print is great. As long as you have a printer capable of printing a good benchy you can print this model with ease with default settings. The only downside is that it will take 4 hours to print 1. We now need to figure out a way to decrease the time of each print.   \t\tLook into ways to change the slicer settings to make the print quicker at the same quality. \t\tVideo Resource: https://www.youtube.com/watch?v=_bt1UZAnxnA\t