3 hole easy stackable remixed Verkstan design with extended side cover

This model has not been assessed for community use or in a clinical setting. Further optimization may be required.

Submitted by:
Sun, 2020-04-12 01:58

Vertical Tabs

QR Code for https://3dprint.nih.gov/discover/3dpx-013798

Rating

No votes yet

Licensing

Builds

Comments

Comments

Can you tell me, is the visor portion of this print long enough to allow for a mask and goggles? It looks very narrow and just want to be sure.

Also, are you stacking this with a small layer gap between the prints? Or are you placing the second level model directly on top of the first?

This design has same visor length as original verkstan design. If the glasses are thick you can keep front side higher and back portion little lower. This will create more room for glasses and mask.

I have not tried this model for stacking. It depends on your printer settings and layer height gaps. If you keep air gap same as one layer height it should work but bottom layer in stacked print can be rough. It can work well with higher quality settings but it adds more time in printing. Hope this helps.