Flex Filter Mask

This model has not been assessed for community use or in a clinical setting. Further optimization may be required.

Submitted by:
Fri, 2020-04-03 09:40

Vertical Tabs

QR Code for https://3dprint.nih.gov/discover/3dpx-013464

Rating

No votes yet

Licensing

Mask on Printer
Mask with Filters
Mask

Comments

Comments

is there any way to make the walls more solid?  Perhaps design them to lend themselves to a vase mode production?  THte small supports are a bit more of a challenge than I want to admit.  I like the design and I like the interlocking aspect of the unit.  it prints a bit too delicatly on the supports/openings for the filtermaterial.  I would wager that you could make the openings 50 percent larger and still be OK. 

You bet!  Visit the link for the updated Version 2 in the product description.  Version 2 was developed shortly after the realease of Version 1 for specifically those reasons!  We've been printinting the Ver2 masks for 6 weeks or so now...

See the link in the item description for Version 2.  It replaced this initial version many weeks ago specifically to provide a more robust/reliable/printable model!